Common problems and solutions in processing UHMWPE special-shaped parts
Common problems and solutions in processing UHMWPE special-shaped parts
| Problem | Cause | Solution |
|---|---|---|
| Many wiredrawing and burrs during cutting | The tool is not sharp enough | Use carbide tools to keep the blade sharp |
| Material deformation during processing | Cutting speed is too fast, friction generates heat | Reduce cutting speed and use air cooling |
| Uneven edges of water jet cutting | Insufficient water pressure or insufficient abrasive | Increase water pressure and increase abrasive concentration |
| Poor bonding after welding | The material surface is smooth and has low adhesion | Grind before welding to improve bonding |
| Large dimensional error of special-shaped parts | Dimensional changes caused by thermal expansion | Consider the thermal expansion coefficient before processing and leave margin |
Products
News and Articles
- where to buy a sheet of plastic?
- What is a Plastic Sheet?
- Plastic Sheet Cutting Guide-How To Cut Plastic Sheet?
- How to cut plastic sheets?
- Synthetic Ice Board Regular Inspection and Maintenance Guide
- Synthetic Ice Maintenance Guide
- Synthetic Ice vs Natural Ice A Comprehensive Comparison Analysis
- plate for Curling
- Outdoor Synthetic Ice Rink
- Which recycled plastics can be used for cutting boards?
